5 Designing Tasks
5-2
NJ-series CPU Unit Software User’s Manual (W501)
5-1 Overview of Task Designing
Procedure
This section provides an overview of the task designing procedure.
The shaded steps in the overall procedure that is shown below are related to the task designing proce-
dure.
Refer to 1-3 Overall Operating Procedure for the NJ-series Controller for details.
Step 1. Software Design
Step 1-1 I/O Processing Design
Step 1-2 Designing Tasks
Step 1-3 Designing Programs
Step 2. Software Setups and Programming
Step 2-1 Slave and Unit Configurations
Step 2-2 Controller Setup
Step 2-3 Programming
Step 2-4 Offline Debugging
Step 3. Mounting and Setting Hardware
Step 4. Wiring
Step 5. Checking Operation and Starting Operation on the
Actual System
To Next Page
Loading...
