Name: Omron NJ Series
Brand: Omron
Rating: 4 (1 reviews)

To Next Page

To Previous Page

7 Checking Operation and Actual Operation

7-2

NJ-series CPU Unit Software User’s Manual (W501)

7-1 Overview of Steps in Checking

Operation and Actual Operation

The shaded steps in the overall procedure that is shown below are related to the checking operation

and actual operation. In Step 2-4. Offline Debugging, a simulation is used to check operation without

going online with the Controller. In Step 5. Checking Operation and Starting Operation on the Actual

System, you go online with the Controller to check the operation of the physical Controller. When check-

ing operation is completed, you start actual operation.

Refer to 1-3 Overall Operating Procedure for the NJ-series Controller for the overall procedure.

Step 1. Software Design

Step 1-1 Designing I/O and Processing

Step 1-2 Designing Tasks

Step 1-3 Designing Programs

Step 2. Software Setups and Programming

Step 2-1 Slave and Unit Configurations

Step 2-2 Controller Setup

Step 2-3 Programming

Step 2-4 Offline Debugging

Step 3. Mounting and Setting Hardware

Step 4. Wiring

Step 5. Checking Operation and Starting Operation on the

Actual System

Other manuals for Omron NJ Series

Questions and Answers:

Need help?

Do you have a question about the Omron NJ Series and is the answer not in the manual?

General