Omron NJ Series User Manual

1 Introduction to NJ-series Controllers
1-6
NJ-series CPU Unit Software User’s Manual (W501)
 Support Software
You can use the following Support Software to set up, monitor, and debug an NJ-series Controller.
Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NJ-series Controller. On it, you
can set up the Controller configurations, parameters, and programs, and you can debug and simu-
late operation.
Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
Configuration software Application
Sysmac Studio
The Sysmac Studio is used for sequence control, motion control, and all other
operations except those described below.
Network Configurator The Network Configurator is used for tag data links on EtherNet/IP ports.
CX-Integrator
The CX-Integrator is used for remote I/O communications with a DeviceNet
Unit or CompoNet Master Unit.
CX-Protocol
The CX-Protocol is used for protocol macros with Serial Communications
Units.
CX-Designer The CX-Designer is used to create screens for NS-series PTs.

Omron NJ Series Specifications

General

Program Capacity	Up to 128 MB
SD Card Slot	Yes
Power Supply Voltage	24 VDC
Motion Control	Yes
USB Ports	1
Operating Temperature	0°C to 55°C
Communication Interfaces	Ethernet/IP, EtherCAT, USB
Safety Function	Optional
Storage Temperature	-20°C to 75°C
Communication Ports	USB
Dimensions	Varies by model
Weight	Varies by model