Omron NJ Series - Page 517

12 Troubleshooting
12-46
NJ-series CPU Unit Software User’s Manual (W501)
Event name Reset Executed Event code 90150000 hex
Meaning A reset was executed.
Source PLC Function Module Source details None Detection
timing
Commands from
user
Error attributes Level Information Recovery --- Log category Access
Effects User program --- Operation Operation is started after a reset is executed.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
A reset command was received. --- ---
Attached
information
None
Precautions/
Remarks
None
Event name User Program Execution ID Write Event code 9016 0000 hex
Meaning The user program execution ID was set or changed in the CPU Unit.
Source PLC Function Module Source details None Detection
timing
When download-
ing
Error attributes Level Information Recovery --- Log category Access
Effects User program Continues. Operation Not affected.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
A user with Administrator rights
changed the user program execution
ID that is set in the CPU Unit.
--- ---
Attached
information
None
Precautions/
Remarks
None
Event name All Controller Errors Cleared Event code 9018 0000 hex
Meaning All current errors were cleared.
Source PLC Function Module Source details None Detection
timing
Commands from
user
Error attributes Level Information Recovery --- Log category Access
Effects User program Continues. Operation Clearing all errors for which the causes have been
removed.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
The user cleared all current errors. --- ---
Attached
information
None
Precautions/
Remarks
None