Optopol SOCT Copernicus +

To Next Page

To Previous Page

SOCT Copernicus PLUS - Service Manual

11. Before assembling forehead rest remember to place external fixation plug inside headrest.

12. Assembly the upper cover.

Main Page

Table of Contents2
Introduction5
Contact to Optopol Technology5
Safety Standards6
Maintenance and Cleaning9
Device Overview9
Technical Data10
Unpacking and Installation11
Unpacking SOCT Copernicus11
Connecting Cables12
Device Connection Diagram15
PC Installation16
Minimum System Requirements16
NI Frame Grabber Card and Winfast Card Installation17
Drivers Installation18
NI Vision Acquisition Software Installation18
USB HUB Drivers Installation27
Winfast TV Card Drivers Installation29
Microsoft Visual C++ Redistributable Installation32
SOCT Software Installation34
Troubleshooting38
Mechanical Troubleshooting38
Electronic Troubleshooting39
Optical Troubleshooting43
Opening and Closing the Device47
Opening Cover47
Closing Cover59
Movement Modules67
Chinrest Module67
Chinrest Module Replace in Devices with Serial Number Higher then 154229/L70
Left-Right Movement Engine72
Front-Backward Movement Engine73
Up-Down Movement Engine75
Electronics80
Device Block Scheme80
Tools Needed to Replace Electronic Components81
Fuse Exchange81
Exchanging Switching Power Supply84
Exchanging Transitional Board 151-52586
(For Devices from S/N: 154012/I to S/N: 154196/L)86
Exchanging Transitional Board 151-527 (for Devices from S/N: 154208/L)88
Exchanging Transitional Board from 151-526 (151-525) to 151-52790
(For Devices from S/N: 154012/I to S/N: 151207/L)90
Main Controller Board 151-50695
Checking Correctness of Feeding on Board 151-50696
Exchanging Board 151-50697
Board 151-51298
Control of Feeding on Board 151-51299
Exchanging of Board 151-512100
Movement Control Board 151 - 517101
Exchange of Board 151 - 517103
Board 151-126104
Checking Correctness Functioning of Board 151-126104
Exchange of Board 151 - 126105
Scanner Controlling Boards106
Exchange of Scanner Driver Boards107
Exchange of Spectrometer Servomechanism Controller Board 151-539108
Checking SLED Diode110
Checking AVIVA Camera Power Supply111
Exchanging CL Cables112
Rear Panel115
Programming the CPU116
Optics121
Spectrometer Adjustments121
No Signal in Skantest Program123
Defocusing of Spectrometer (too Wide Peak)125
Too Low Spectrum on Skantest128
Too High Spectrum on Skantest130
Checking and Adjusting Power on Objective Lane131
Setting Fixation Point to the Centre of the Cross135
Checking and Adjusting the Polarization144
Checking, Adjusting and Exchange of Scanners150
Exchanging of Scanner y152
Exchanging Scanner X157
Correcting Scanner Setup163
Cleaning Optics167
Regulation of Filter on Reference Lane171
Checking of SLED Output Power, Checking Attenuator174
Crossing the Spectrometer178
Spectrometer Stability Test179
Faq180
Spare Parts List188
Service Tools198

Optopol SOCT Copernicus + - Page 65

Table of Contents

Related product manuals