Oracle Database Appliance X6-2-HA

Install Boot Disk Backplane Cables
b.
Disconnect the power cable and HDD cables from the boot disk backplane
[2].
Install Boot Disk Backplane Cables
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes installing the boot disk backplane cables in Oracle Database Appliance
Version 1.
1.
Reconnect the power cable and hard disk drive (HDD) cables.
a.
Reconnect the power cable and HDD cables to the boot disk backplane [2].
b.
Reconnect the power cable and HDD cables to the motherboard [1].
2.
Return the server node to operation.
a.
Install the server node top cover.
See “Installing the Server Node Top Cover” on page 245.
Appendix A • Servicing the Oracle Database Appliance Version 1 239