How to Replace a ZS3-2 PCIe Card or Riser
16.
Lower the riser card onto the motherboard and press the card edge connector
securely into the socket. The bracket of the riser (riser 2 and 3) overlaps the
bracket of the adjacent riser.
17.
Tighten the two captive screws that secure the riser to the motherboard.
18.
Replace the top cover and tighten the two captive screws.
19.
Push the release tabs on the side of each rail and slowly push the storage
controller into the rack, making sure no cables obstruct the path of the
controller.
20.
Reconnect the data cables and the disk shelf cables.
21.
Connect the power cords to the power supplies. Verify that standby power is on,
indicated by the Power/OK and SP status indicators flashing green on the front
panel.
22.
After the SP status indicator is solid green, use a pen or other pointed object to
press and release the recessed Power button on the front panel. The Power/OK
status indicator next to the Power button lights and remains lit.
Servicing the Hardware 151
To Next Page
Loading...
Need help?
General