How to Replace a ZS4-4 PCIe Card
8.
Lower the memory riser card into the controller and set it on the slot on the
motherboard.
9.
Ensure that the memory riser card connector is aligned with the slot.
10.
Firmly push down on the metal bracket on top of the card, to seat the card within
the connector on the motherboard.
11.
Replace the top cover on the chassis.
12.
Return the controller to the normal rack position by pushing the release tabs on
the side of each rail while slowly pushing the storage controller into the rack.
13.
Reconnect the power cords to the power supplies.
14.
Verify that standby power is on, indicated by the Power/OK status indicator
flashing on the front panel about two minutes after the power cords are plugged
in.
15.
Use a pen or other pointed object to press and release the recessed Power
button on the storage controller front panel.
16.
Go to the Maintenance > Hardware screen of the BUI. Click the right-arrow icon
for the controller and then click DIMM to verify that the status icon is green
for the newly installed memory riser card.
How to Replace a ZS4-4 PCIe Card
Replacing a PCIe card is a cold-swap procedure, and you must remove power from the storage
controller. If you are installing a newly released HBA, upgrade your system software before
68 Oracle ZFS Storage Appliance Customer Service Manual • February 2016
To Next Page
Loading...
Need help?
General