How to Replace a ZS3-2 Memory
9.
Lower the fan module into the fan tray and press down until the module clicks
securely in the fan tray.
10.
Replace the top cover and tighten the two captive screws.
11.
Push the release tabs on the side of each rail and slowly push the storage
controller into the rack, making sure no cables obstruct the path of the
controller.
12.
Reconnect the data cables and the disk shelf cables.
13.
Connect the power cords to the power supplies. Verify that standby power is on,
indicated by the Power/OK and SP status indicators flashing green on the front
panel.
14.
After the SP status indicator is solid green, use a pen or other pointed object to
press and release the recessed Power button on the front panel. The Power/OK
status indicator next to the Power button lights and remains lit.
15.
Verify that the Fan OK status indicator is lit, and that the fault status indicator on
the replaced fan module is dim.
How to Replace a ZS3-2 Memory
Caution - This procedure requires that you handle components that are sensitive to static
discharge, which can cause the component to fail. To avoid damage, wear an antistatic wrist
strap and use an antistatic mat when handling components.
138 Oracle ZFS Storage Appliance Customer Service Manual • February 2016
To Next Page
Loading...
Need help?
General