How to Replace a 7x20 HDD or SSD
4.
Grasp the latch (2), and pull the drive out of the drive slot.
5.
After at least 30 seconds, navigate to the Hardware > Maintenance screen, and
click the right-arrow icon on the system controller to verify that the software
has detected that the drive is not present.
6.
Slide the replacement drive into the slot until it is fully seated.
7.
Close the latch to lock the drive in place.
196 Oracle ZFS Storage Appliance Customer Service Manual • February 2016
To Next Page
Loading...
Need help?
General