Chapter 1. Programming Site Data
12 DigitalFlow™ DF868 Multipurpose Ultrasonic Liquid Flowmeter Programming Manual (2-Channel)
1.6.2.1 Mass Flow
If the Mass Flow prompt in the SETUP submenu is not enabled, skip this sub-section. However, the following
programming sequence appears if Mass Flow is enabled.
1. Press [F1]-[F4] to select the desired Mass Flow units for the flow rate display.
Note: The option bar above shows English units, as an example. If Metric units were specified, these appear
instead.
The abbreviations and definitions of all the available mass flow units are shown in Table 4. The choices shown on the
option bar are determined by the selections made at the SYSTEM UNITS prompt.
2. Press [F1]-[F4] to select the desired Time units for the mass flow rate display.
3. Press [F1]-[F4] to select the desired number of Decimal Digits (digits to the right of the decimal point) in the
mass flow rate display.
4. Press [F1]-[F4] to select the desired Totalizer Units for the totalized mass flow display.
Note: The option bar above shows English units, as an example. If Metric units were specified, these appear
instead.
The available mass flow units are shown in Table 4. The choices shown on the option bar are determined by the
selections made at the SYSTEM UNITS prompt.
5. Press [F1]-[F4] to select the desired number of Decimal Digits (digits to the right of the decimal point) in the
totalized mass flow display.
Table 4: Available Mass Flow Units
English Metric
LB = Pounds KG = Kilograms
KLB = Thousands of LB TONNE = Metric Tons (1000 KG)
MMLB = Millions of LB
TONS = Tons (2000 LB)
To Next Page
Loading...
