DigitalFlow™ DF868 Multipurpose Ultrasonic Liquid Flowmeter Programming Manual (2-Channel) 83
Chapter 4. Printing Data
4.6 Stop Printing
Use the STOP submenu to terminate the printing of live, logged or site data. To stop any active printing activity, see
Figure 16 on page 103, and complete the following steps:
IMPORTANT: Make sure that a printer has been properly set up before proceeding with this section.
1. To access the Print Menu, press the [PRNT] key.
Note: The Print Menu is not
protected by the security feature and a password is never required to access this
menu.
2. Press [F4] = STOP.
3. Press [F1] to continue printing or press [F2] to Stop the currently active printing job.
Note: After the STOP command has been issued, the printer will complete the printing of any data already in the
printer buffer. Either wait for the printer to finish or turn the printer off to empty the buffer immediately.
The Model DF868 returns to the standard data display screen and normal measurement taking.
To Next Page
Loading...
