DigitalFlow™ DF868 Multipurpose Ultrasonic Liquid Flowmeter Programming Manual (2-Channel) 41
Chapter 1. Programming Site Data
Procedure Options
After completing the above steps, the meter returns to the Global PROGRAM. Continue as follows:
• To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of this manual for instructions.
• To leave the User PROGRAM and retain the previous settings, press [EXIT] twice and then press [F1] = NO at the
SAVE prompt. Any programming changes will be discarded and you will be returned to the data display.
• To leave the User PROGRAM and return to measurement mode, press [EXIT] twice and then press [F2] = YES at
the SAVE prompt. Your programming changes will be entered into the meter’s memory, and you will be
returned to the data display.
To Next Page
