......
o
OPERATING INSTRUCTIONS
Troubleshooting
Check
out
the
points
in
the
table
given
below,
and
consult
w~h
your dealer if
the
trouble should persist.
Trouble
No
power
No
operation
even
when
an
operation button
is
pressed
No recording
Noise appears
on
playback
pictures.
No repeat playback
No VISS signal writing
Error Display
Checkpoint/Remedial
Action
• Has the power cable been connected?
•
Is
the
power
switch
in
the
ON
position?
• Has a cassette tape been loaded?
•
Is"
d"
displayed indicating condensation lighted?
Keep the power supplied to the unit and wait until
the"
d "
in
display goes off.
•
Is
the Mode Lock Switch at the OFF position?
• Has
the
tape's accidental erasure prevention tab been
broken out?
• Has the INPUT Selector been set to the proper position?
• Press the Tracking Buttons and adjust.
• Has the MEMORY (MEMO) Button been set to the proper position?
• Has the counter been reset?
•
Is
the VISS setting on the menu screen at OFF?
• Has
an
interval of
at
least 20 seconds been given between
BEGIN and END?
•
Is
the VISS setting on the menu screen at REC
or
REC/PAUSE?
•
Has an interval of
at
least 30 seconds been given between
one
VISS and another VISS signal?
ReI. Page
E-19
E-15
E-14
E-15, E-16
E-11
E-11
E-9
E-13
E-9
E-12
The following error messages will
be
displayed
on
the tape counter if
an
abnormality occurs
in
the unit.
In
this case, follow
instructions
described
below.
• When an error code appears:
•
An
error code appears
on
the display.
•
All
operations
are
shut
down
when
an
error
code
appears
on
the
display.
• If the error is not released even after taking the remedial action described below, switch off the power, disconnect the power
cable from the power outlet, and contact your dealer immediately.
• List
of
error
codes
Error Code Malfunction
Remedial action
E
-
C'
Malfunction
in
elevator
These
errors
may
occur
if
the
video
section
cassette has not been loaded
properly.
E
-
:1
Malfunction in loading
Try switching the power off and
-,
section
turning
it
back
on
again.
E
-
,-,
Malfunction
in
cylinder
These
errors
may
occur
if
there
is
,
section
something wrong with the state of
C
-
C
Malfunction
in
reel
section
the video cassette. Try switching the
!..
-,
power off and turning it back on
E
-b
Incorrect
tape
tension
again and replacing the video
cassette.
E
-
-,
Malfunction
in
solenoid
Try switching the power off and
,
turning
it
back
on
again.
-
E-20-
To Next Page
Loading...
