Panasonic FP Series Technical Manual

FP Modem-EU Technical Manual
Table of Contents
3.10 Transmission Modes................................................................................ 48
3.11 Terminating the Handshaking Phase....................................................... 49
3.12 Disconnection with the Break Signal ....................................................... 50
3.13 Communication Methods and Protocols.................................................. 51
3.14 Error Correction and Data Compression ................................................. 52
3.15 Modem Self-Diagnostic Function............................................................. 53
3.16 PLC Remote Programming with FPWIN Pro........................................... 54
3.17 Modem Library for FPWIN Pro ................................................................ 55
4. Cable Networks/Permanent Connections..........................57
4.1 Leased Line Mode ................................................................................... 58
4.1.1 Usage on Leased Line or Private Cable ..................................................58
4.1.2 Enable Leased Line Mode with DIP Switches ......................................... 58
4.1.3 Recommendations for Leased Line Mode ...............................................59
4.1.4 Maximum Line Length.............................................................................. 60
4.2 Multipoint Operation................................................................................. 61
4.2.1 Enable Multipoint Mode with DIP Switches..............................................62
4.2.2 Description of Multipoint Operation.......................................................... 63
4.2.3 Error Correction in Multipoint Mode .........................................................64
4.2.4 Terminating Resistor ................................................................................ 64
4.2.5 Maximum Line Length.............................................................................. 66
iii

Panasonic FP Series Specifications

General

Mounting	DIN rail
Type	PLC
Communication Interface	RS-232, RS-485, Ethernet (depending on model)
Input Voltage	100-240V AC or 24V DC (depending on model)
Output Type	Relay, Transistor
I/O Points	Varies by model
Operating Temperature	0°C to 55°C
Dimensions	Varies by model
Weight	Varies by model