Appendix
FPΣ User's Manual
298
No. Name Default Values
414
COM port 2 - sending start code No-STX No-STX/STX
414
COM port 2 - sending end code/reception done
condition
CR CR/CR+LF/ETX/None
418
COM port 2 - receive buffer starting address 2048 0–32762
419
COM port 2 - receive buffer capacity 0 0–2048
412
COM port 2 - modem connection Disable Disable/Enable
1)
For PLC Link, the communication format and baud rate settings are fixed:
Data length: 8 bits
Parity: Odd
Stop bit: 1 bit
End code: CR
Start code: No STX
Other system register settings will be ignored.
2)
FPG-COM4: For RS485 connections (COM port 1), the baud rate must be set in the system registers and with
the DIP switch.
To Next Page
Loading...
Need help?
General
