Panasonic KX-HDV130

6. [ ]/[ ]: "Auto" ®
OK
• Select "Manual" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then press
OK
.
To configure network settings automatically using RA
1.
2. [ ]/[ ]: "System Settings" ®
OK
3. [ ]/[ ]: "Network Settings" ®
OK
4. [ ]/[ ]: "IPv6 Settings" ®
OK
5. [ ]/[ ]: "RA" ®
OK
6. Enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2 (secondary DNS server)
manually, and then press
OK
.
To configure network settings manually
1.
2. [ ]/[ ]: "System Settings" ®
OK
3. [ ]/[ ]: "Network Settings" ®
OK
4. [ ]/[ ]: "IPv6 Settings" ®
OK
5. [ ]/[ ]: "Static" ®
OK
6. Enter the IP address, Prefix (for IPv6), Default Gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then press
OK
.
Note
• If your phone system dealer/service provider does not allow you these settings, you cannot change
them even
though the unit shows the setting menu. Contact your phone system dealer/service provider
for further information.
• If you select "DHCP" for the connection mode, all the settings concerning static connection will be
ignored, even if they have been specified.
• If you select "DHCP" for the connection mode and "Auto" for DNS, the DNS server settings (DNS1 and
DNS2) will be ignored, even if they have been specified.
1.1.4 Overview of Programming
There are 3 types of programming, as shown in the table below:
Programming
Type
Description References
Phone user
interface
programming
Configuring the unit’s settings directly from the unit.
® 1.1.5 Phone User Interface
Programming
®
Section 3 Phone User
Interface Programming
Web user
interface
programming
Configuring the unit’s settings by accessing the Web
user interface from a PC connected to the same
network.
® 1.1.6 Web User Interface
Programming
® Section 4 Web User
Interface Programming
Configuration file
programming
Configuring the unit’s
settings
beforehand by creating
configuration files (pre-provisioning), and having the
unit download the files from a server on the Internet
and configure its own settings (provisioning).
® Section 2 General
Information on Provisioning
® Section 5 Configuration
File Programming
Document Version 2015-12 Administrator Guide 25
1.1.4 Overview of Programming