Configuration File Reference DIAL_TONE4_FRQ (Page 293)
Tone Timings
Description Specifies the pattern, in milliseconds, of stutter dial tones to notify that
a
voice mail is waiting, using up to 22 whole numbers (off 1, on 1, off 2,
on 2…) separated by commas.
Note
• It is recommended that you set a value of 560 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 560,100,100,100,100,100,100,100,100,100,100,100,100,100,100,10
0,100,100,100,100,100,0
Configuration File Reference DIAL_TONE4_TIMING (Page 293)
4.6.5.5 Reorder Tone
Tone Frequencies
Description Specifies the dual-tone frequencies, in hertz, of reorder tones using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Note
• If
the value for this setting is "480,620", the unit will use a mixed
signal of a 480 Hz tone and a 620 Hz tone.
Default Value 480,620
Configuration File Reference REORDER_TONE_FRQ (Page 295)
Tone Timings
Description Specifies the pattern, in milliseconds, of reorder tones using up to 10
whole numbers
(off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Document Version 2015-07 Administrator Guide 153
4.6.5 Tone Settings
To Next Page
Loading...
