REG_INTERVAL_RATE_n
Parameter Name Example REG_INTERVAL_RATE_1, REG_INTERVAL_RATE
_2, ...,
REG_INTERVAL_RATE_6
Value Format INTEGER
Description Specifies the percentage of the "expires" value after which to refresh
registration
by sending a new REGISTER message in the same dialog.
Value Range 1–100
Default Value 50
REG_RTX_INTVL_n
Parameter Name Example REG_RTX_INTVL_1, REG_RTX_INTVL
_2, ..., REG_RTX_INTVL_6
Value Format INTEGER
Description Specifies the interval, in seconds, between transmissions of the
REGISTER request when a registration results in failure
(server no
reply or error reply).
Value Range 1–86400
Default Value 10
USE_DEL_REG_OPEN_n
Parameter Name Example USE_DEL_REG_OPEN_1, USE_DEL_REG_OPEN
_2, ...,
USE_DEL_REG_OPEN_6
Value Format BOOLEAN
Description Specifies whether to enable cancelation before registration when, for
example, the unit is turned on.
Value Range
• Y: Send un-REGISTER
• N: Does not send
Default Value
N
USE_DEL_REG_CLOSE_n
Parameter Name Example USE_DEL_REG_CLOSE_1, USE_DEL_REG_CLOSE
_2, ...,
USE_DEL_REG_CLOSE_6
Value Format BOOLEAN
Description Specifies whether to enable the cancelation of registration before the
SIP function shuts down when, for example, the configuration has
changed.
248 Administrator Guide Document Version 2015-07
5.3.22 SIP Settings
To Next Page
Loading...
