Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range
1–7 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to
"MIN_DELAY"
– This value must be less than "MAX_DELAY"
Default Value 1
RTP_PORT_MIN
Value Format INTEGER
Description Specifies the lowest port number that the unit will use for RTP packets.
Value Range 1024–59598 (only even)
Default Value 16000
Web User Interface Reference Minimum RTP Port Number (Page 129)
RTP_PORT_MAX
Value Format INTEGER
Description Specifies the highest port number that the unit will use for RTP packets.
Value Range 1424–59998 (only even)
Default Value 20000
Web User Interface Reference Maximum RTP Port Number (Page 130)
RTP_PTIME
Value Format INTEGER
Description Specifies the interval, in milliseconds, between transmissions of RTP
packets.
Value Range
• 20
• 30
• 40
Default Value 20
Web User Interface Reference RTP Packet Time (Page 129)
RTP_TARGET_CHECK
Value Format INTEGER
272 Administrator Guide Document Version 2015-07
5.3.26 RTP/RTCP/RTCP-XR Settings
To Next Page
Loading...
