For information about the system prompt languages in each SD Memory Card, refer to "9.1
System Prompt
Languages".
The system prompt language data you are using on the installed SD Memory Card must be backed up if
you want to continue using that SD Memory Card’s system prompt language data. After backing up the
system prompt language data, install the optional SD Memory Card, and then restore the backed up system
prompt language data to the new SD Memory Card.
This procedure is described below.
1. Insert a USB memory device into the USB port of the PBX.
(For details, refer to "Using a USB memory device" in "4.10 Connection of Peripherals".)
2. Back up the desired system prompts to the USB memory device.
(For details, refer to "6.8 Tool—UM Data Backup" in the PC Programming Manual.)
3. Shut down the PBX, and then turn the power switch off.
(For details about shutting down the PBX, refer to "5.4 System Control—System Shutdown" in the PC
Programming Manual.)
4. Remove the SD Memory Card, and then install an optional SD Memory Card.
(For details, refer to "4.3.2 SD Memory Cards".)
5. Start the PBX as described in "System Initialization Procedure" in "4.13 Starting the PBX".
6. Perform Easy Setup Wizard.
(For details, refer to "5.4.1 Easy Setup Wizard".)
7. Restore the system prompts backed up in step 2. For details, refer to "6.9 Tool—UM Data Restore" in the
PC Programming Manual.
98 Installation Manual Document Version 2016-03
4.2.6 Installing/Removing the SD Memory Card
To Next Page
Loading...
Need help?
General