1.24 Hospitality Features
184 Feature Guide
[Example Use: Check-in Mode]
Conditions
• Only one of each type of Room Status Control button can be assigned.
• Extensions associated with rooms must be one of the following types:
PT (including IP-PT), SLT, T1-OPX
PSs cannot be checked in and out as room extensions.
• When using extensions to represent guest rooms, it is recommended to set the extension number the
same as the room number, for convenience.
• Check-in and check-out information is recorded by SMDR.
• When in Room Status Control mode, the hotel operator's extension can only perform operations related
to that room status (e.g. Check-in). All other operations, including pressing other Room Status Control
buttons, will be ignored. In addition, the lights of fixed and flexible buttons do not show their normal
display pattern. To perform other operations, first exit the current Room Status Control mode.
• When in Room Status Control mode, the hotel operator's extension is treated as a busy extension,
similar to when performing PT programming. Callers to that extension will hear a busy tone.
Connection References
2.3.2 MEC Card
Feature References
1.6.1.3 Last Number Redial
1.8.2 Extension Lock
1.23.1 Station Message Detail Recording (SMDR)
1.25.4 Timed Reminder
Operation References
2.1.6 Hospitality Features
Light Pattern Status
Off Check-out
Red on Check-in
Room101
DSS button
Room102
Room103
Room104
Room105
Check-in button
Check-out button
Rooms 101 and 103
are currently in
check-in status.
To Next Page
Loading...
