Panasonic KX-TDA100

2.3 System Data Control
Feature Guide 249
2.3.4 Automatic Time Adjustment
Description
The PBX clock can be adjusted automatically in the following two ways:
1. Daylight Saving Time Setting
The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically
adjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through
system programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00
A.M. on the end date, the clock will change to 1:00 A.M.
Note
If a Timed Reminder (Wake-up call) is set:
– On the Daylight Saving Time start date, a reminder set for between 2:00 A.M. and 3:00 A.M.
will not ring.
– On the Daylight Saving Time end date, a reminder set for between 1:00 A.M. and 2:00 A.M.
will ring twice.
Item Parameter Description
Date & Time Set Year/Month/Date/
Hour/Minute
The date and time set on the PC can be used by default.
System
Password for
Installer
4–10 characters Enter the system password for installer (→ 3.1 Introduction).
Operator &
Manager
Extension
Number
Assign a PBX operator. (→ 2.2.5 Operator Features) This
extension will be the operator for all time modes, and is
automatically assigned manager status to perform manager
operations. (→ 2.2.6 Manager Features)
Flexible
Numbering Type
1. Pattern 1
(with )
2. Pattern 2
(without )
Select whether or not the prefix " " must be entered before dialing
feature numbers.
[Example] Call Pickup feature number
Pattern 1 (with ): 41
Pattern 2 (without ): 41
Note that certain feature numbers (Line Access numbers, Operator
Call, etc.) never need this prefix.
For a list of the default flexible numbers, refer to the [Flexible
Numbering Table (available while a dial tone is heard)] (→ 2.3.5
Flexible Numbering/Fixed Numbering).
Operator/Local
Access
1. 0/9
2. 9/0
Select the feature numbers for Operator Call and Idle Line Access.
These will be either 0 and 9, respectively, or 9 and 0, respectively.
Remote
Maintenance
Number
Remote
Maintenance Dial
Number
Enter the complete telephone number of the PBX (including the
country code). When necessary, this number will be used to access
the PBX from a remote location for maintenance purposes.