Panasonic KX-TDA100

4.5 Utility
332 Feature Guide
Click in the hour or minute field and use the up and down arrows to adjust the displayed time in
increments of one unit.
4. Click Apply.
A message box will be displayed.
5. Click OK.
To turn this utility off:
1.
From the Utility menu, select Timed Update.
2. Select the Off (Cancel) option.
3. Click Apply.
A message box will be displayed.
4. Click OK.
4.5.17 Utility—System Reset—Reset by the Command
Updates the main system program and data files stored within the PBX using files taken from the SD
memory card, and resets the connected PBX.
This option is only available at Installer level.
2 copies each of the main system files can be stored on the SD memory card. The names of these files are
as follows:
When new DSYS and PMPR files are transferred from an attached PC to the SD memory card using the
File Transfer PC to PBX (SD Card) utility (see "4.5.2 Utility—File Transfer PC to PBX (SD Card)"), they
are stored as the backup files. To use these files on the PBX, it is necessary to first swap them with the
currently active files on the SD memory card.
Requirements
• This utility functions on PBXs with MPR version 1.005 or later.
• On earlier versions, the reset request confirmation screen will be displayed, and files will not be
updated.
To update system files and reset the PBX
1.
From the Utility menu, point to System Reset and then click Reset by the Command.
2. Choose whether to back up current system data or not.
•Click SD Backup to back up the current system data to the SD memory card before proceeding.
Select this if you intend to use the current system data unchanged after reset.
File Name Description
DSYS Main system data file. Contains all of the current configuration data
for the PBX.
DSYS_SUB Backup main system data file
PMPR PBX program file. Contains the software to run the MPR board of
the PBX.
PMPR_SUB Backup PBX program file