Panasonic KX-TDA100

2.3 System Data Control
Feature Guide 247
• Programmer Code and Password for System Programming
To access system programming, a programmer code and its password must be entered. For more
details, see Section 3.1 Introduction.
• Remote Programming Limitation
It is possible to disable remote access through system programming (→ Remote Programming [810]).
Disabling this feature will also disable the ability to perform on-site programming via modem or ISDN
TA.
• If an extension user sets Walking Extension at the same time that the extension's data is being
programmed through PC programming, the data may not be transferred properly. (→ 1.25.3 Walking
Extension)
Connection References
2.3.1 MPR Card
2.3.3 RMT Card
2.6.6 CTI-LINK Card
3.1 Overview
3.2 Connection
3.3 Installation of the KX-TDA Maintenance Console
Feature References
1.1.1.2 Direct In Line (DIL)
1.1.1.3 Direct Inward Dialing (DID)
3.2 PC Programming
2.3.2 PT Programming
Description
A proprietary telephone (PT) can be used to customize the settings of the PBX or of an extension, using the
following programming features:
Programming
Type
Description Example
Authorized
Programmer
Personal
Programming
Used by an extension user to
customize the extension's settings.
PT Display Language,
Call Waiting Tone, etc.
Extension user
System
Programming
Used by an authorized party to
customize the PBX.
Intercept Destination,
ARS Mode, Date and
Time, etc.
Authorized
administrator or
extension user
Manager
Programming
Used by an extension assigned as a
manager to customize the current
state of an extension, or to grant
special privileges temporarily to an
extension user.
Switching the current
time mode, Remote
Extension Lock, Remote
PIN Clear, etc.
Extension assigned
as a manager