Panasonic KX-TDA100

3.3 PT Programming
Feature Guide 273
Entering System Programming Mode
Using a PT to perform system programming allows an authorized extension user to set a wide range of PBX
features and parameters.
There are two levels of system programming that can be performed with a PT—administrator level
programming and user level programming.
Administrator Level: All system programming that can be performed with a PT is accessible.
User Level: System programming that has been made accessible to PT users through PC programming
can be performed.
Note
is used throughout these pages to indicate the default value for the given setting.
Programming Structure
Programming Number Programming Group Title Description
[0XX] Basic Programming Frequently used programming steps
[1XX]
System Management
Programming
Global system parameters
[2XX] Time Programming Flexible system timers
[3XX]
TRS/ARS Programming Toll Restriction (TRS) and Automatic Route
Selection (ARS) parameters
[4XX] CO Line Programming CO line and CO line group settings
[5XX] COS Programming COS parameters
[6XX] Extension Programming Assignment of extension features
[7XX]
Resource/Interface
Programming
Assignment of various interfaces of the PBX
[8XX]
SMDR & Maintenance
Programming
Setting of Station Message Detail Recording
(SMDR) and maintenance features
[9XX]
Card Programming Used to display the cards currently installed in
the PBX, or to "delete" a card from system
programming before physically removing it.
PROGRAM/
PAUSE
#
= 1234
System Password for Administrator
Programming No.
3 digits
—for PT Programming
= 1234
Programming No.
3 digits
System Password for User
—for PT Programming
PROGRAM/
PAUSE