Panasonic KX-TDA100 - Page 239

2.2 System Configuration—Software
Feature Guide 239
[Programming Example: Time Table]
[Visualization of Time Schedule for Tenant 1]
Note that in this example, the day mode (Day 2) resumes automatically when the break mode (Break
1) ends.
[Visualization of Time Schedule for Other Tenants]
Note that time modes can be arranged as they are needed (for example, night mode can occur in the
morning and afternoon, if necessary) and not all time modes need to be used in a tenant's time
schedule.
Also note that Tenant 4's Break 1 is followed by the night mode because no end time is programmed
for the break.
3. Features Using Time Service
The following features can be programmed separately for each time mode:
a) Destination of incoming CO line calls (Direct In Line (DIL)/Direct Inward Dialing (DID)) (→
1.1.1 Incoming CO Line Call Features)
b) Destination of calls handled by Intercept Routing (→ 1.1.1.5 Intercept Routing)
c) Destination of calls that are overflowed while waiting in a queue for an available agent of an
incoming call distribution (ICD) group (→ 1.2.2.5 Overflow Feature)
MON
TUE
Day 1
Lunch
Day 2
Break 1 start
Break 1 end
Break 2 start
Break 2 end
Night
Day 1
09:00
12:00
13:00
15:00
15:15
18:00
09:00
1234
15:00
18:30
19:00
20:30
20:45
22:30
22:45
01:00
15:00
11:00
22:00
11:00
12:00
15:00
18:00
06:00
21:00
21:15
06:15
Time Schedule
Time Table No. (Tenant No.)
Time Table No. 1
09:0006:00 12:00 15:00 18:00 21:00 00:0000:00 03:00
Night NightDay 1 Day 2 Break 1Lunch
Monday Tuesday
Time Table No. 2
Time Table No. 3
Time Table No. 4
09:0006:00 12:00 15:00 18:00 21:00 00:0000:00
Monday
03:00
NightDay BreakLunch
Tuesday