Panasonic KX-TDA100

1.1 Incoming Call Features
24 Feature Guide
[Programming Example: DID Table]
In this example:
If the DID number is "123-4567":
1) The PBX looks for the DID number in the table and finds it in location 1.
2) The PBX checks the time mode.
In day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI
destination, if assigned. If not assigned, the call is routed to the DID destination, extension 105,
and "Sales" is displayed.
In lunch mode: CLI distribution is disabled. The call is routed to the DID destination, extension 100,
and "Sales" is displayed.
Note
Tenant numbers and VPS trunk (CO line) group numbers (not shown here) can also be programmed
in the DID Table.
The tenant number programmed here is used only to determine the Time Table used by each DID
number; selecting tenant 3 means the DID number will use Time Table 3, for example. The VPS trunk
(CO line) group number set here is used to determine the Incoming Call Service and greeting message
used by the Voice Processing System (VPS) during the current time mode. (→ 1.21.2 Voice Mail DPT
(Digital) Integration).
Conditions
• To use this feature, DID must be assigned as the distribution method for the desired CO line port.
Feature References
1.1.1.4 Calling Line Identification (CLI) Distribution
2.2.4 Time Service
*1
→ DID Number [451]
*2
→ DID Name [452]
*3
→ DID Destination [453]
Location
1
2
DID
Name
*2
Sales
Judy
DID No.
*1
123-4567
123-2468
Day
Enable
Enable
Lunch
Disable
Disable
Night
Disable
Disable
Break
Enable
Disable
Day
105
102
Lunch
100
100
Break
105
102
CLI Distribution DID Destination
*3
Night
100
100