2.2 System Configuration—Software
Feature Guide 241
Note
Pressing a Time Service button will change the current time mode only if the COS assigned to the
extension is authorized to do so (→ Time Service Manual Switching [514]) or if the extension is
assigned as a manager. All other extension users can press this button on their proprietary
telephones (PTs) to display the current time mode.
Conditions
• The start times of the following time modes can be specified through PC programming as well as PT
programming (→ Time Service Starting Time [102]).
– Day 1 and 2
–Lunch
– Night
The start and end times of the following break modes can be specified through PC programming only.
–Break 1
–Break 2
–Break 3
Note that if an end time is programmed for a break, the day mode will start or resume at this time, as
shown previously in "Visualization of Time Schedule for Tenant 1" example. If no end time is
programmed, the break will continue until the start of the next time mode, as shown in Time Table 4 in
"Visualization of Time Schedule for Other Tenants".
• Time Service Switching Mode (Automatic/Manual) Button
Any flexible button can be customized as the Time Service Switching Mode (Automatic/Manual) button.
Feature References
1.8.1 Toll Restriction (TRS)
1.18.2 Flexible Buttons
2.2.3 Tenant Service
Operation References
1.7.9 Time Service
2.1.2 Time Service Mode Control
Light Pattern Current Time Mode
Off Day
Red on Night
Green on Lunch
Slow green flashing Break
Slow red flashing Holiday
To Next Page
Loading...
