Panasonic KX-TDA100 - Page 315

4.4 Tool
Feature Guide 315
To import system data
1.
From the Tool menu, point to Import, and then click the type of data to import.
2. Navigate to the folder containing the system data file you want to open.
3. Select the file.
4. Click Open to open the file.
A list of field names found in the imported file will be displayed.
5. For the Feature - Speed Dial and Caller ID table, when an MEC card is installed, select the Speed
Dial table to which to import the data (system or tenant) from the drop-down list.
6. Click the name to select a field that you want to import.
7. Click Import to.
8. From the drop-down list, select the field in the destination table to receive this data.
Use the tables above for reference.
9. Click OK to link the fields.
If data in a field being imported does not match the required format for the import destination, an error
message will be displayed when the import operation is attempted, and the operation will be cancelled.
This can occur when, for example, the destination field can only accept numeric data, but the data being
imported contains alphabet characters, as the correct fields were not linked together.
10. Repeat steps 5 to 8 for other fields as required.
11. Click OK to perform the import operation.
CLI Ring for DID-Night CLI Ring - Night 4.16.3 DID Table [10-3]
ARS - Leading Digit
Data Type Import Destination Reference
No. Location 4.14.2 Leading Number [8-2]
Leading Number Leading Digit 4.14.2 Leading Number [8-2]
Additional Number of Digits Additional Dial Digits 4.14.2 Leading Number [8-2]
Routing Plan Number Route Plan Number 4.14.2 Leading Number [8-2]
ARS - Except Code
Data Type Import Destination Reference
No. Location 4.14.6 Leading Number Exception
[8-6]
Leading Number Exception Exception Code 4.14.6 Leading Number Exception
[8-6]
ARS - Routing Plan
Data Type Import Destination Reference
(no fields to select) (no fields to select) 4.14.3 Routing Plan Time [8-3]
Incoming Call - DID Table
Data Type Import Destination Reference