Panasonic KX-TDA100

4.5 Utility
Feature Guide 319
To perform a card test
1.
From the Utility menu, select Diagnosis.
2. Click on the Status cell of the card to be tested, and set it to "OUS".
3. Click on the cell showing the card type.
A new window will be displayed.
4. Select the Card Test option.
A new window will be displayed.
5. Click OK to perform the test(s).
The error report will be displayed. When all tests are completed, the words "Test End!" will be shown
on the last line of the output.
6. Select an option:
•Click Capture if you want to save the displayed information.
1. Enter a file name, or select a file to overwrite.
2. Click Save.
•Click Cancel to return to the Diagnosis screen.
Pair Port Test
Tests the combination of an extension port and CO line port to ensure that communication with the CO line
port can be carried out successfully.
The pair port test can be carried out using one LCOT card and one DHLC, SLC8, SLC16, or MSLC16 card.
The tests that are performed are as follows:
Caller ID card loop back
diagnosis
Extension mode setting test
CTI-LINK loop back
diagnosis
IP-GW H.323 call simulate
diagnosis
LAN loop back diagnosis
Line current OFF (Ext—>CO) Line current from extension to CO line turns off.
Line current ON (Ext—>CO) Line current from extension to CO line turns on.
Off hook detection (CO—>Ext) Off-hook generation/detection from CO line to
extension
DHLC DLC SLC8 SLC16/MSLC16 CSIF LCOT T1 PRI OPB CTI-LINK IP-GW4 (TDA0484) IP-GW16 IP-EXT