Panasonic KX-UT133-B - RTCP Interval; Jitter Buffer; Maximum Delay; Minimum Delay

Configuration File Reference RTCP_ENABLE_n (Page 205)
RTCP Interval
Description Specifies the interval, in seconds, between RTCP packets.
Value Range 5–65535
Default Value 5
Configuration File Reference RTCP_INTVL_n (Page 202)
4.5.4.3 Jitter Buffer
Maximum Delay
Description Specifies the maximum delay, in 10-millisecond units, of the jitter buffer.
Value Range
3–50 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than [Initial Delay]
– This value must be greater than [Minimum Delay]
– [Initial Delay] must be greater than or equal to [Minimum
Delay]
Default Value
20 (´ 10 ms)
Configuration File Reference MAX_DELAY_n (Page 202)
Minimum Delay
Description Specifies the minimum delay, in 10-millisecond units, of the jitter buffer.
Value Range
1 or 2 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be less than or equal to [Initial Delay]
– This value must be less than [Maximum Delay]
– [Maximum Delay] must be greater than [Initial Delay]
Default Value
2 (´ 10 ms)
Configuration File Reference MIN_DELAY_n (Page 203)
Initial Delay
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Document Version 2011-06 Administrator Guide 105
4.5.4 VoIP Settings [Line 1]–[Line 4]