1.1.5.1 Changing the Language for Phone User Interface Programming
You can change the language used on the LCD. Because the language settings for the LCD of the unit are
not synchronized, you must set the languages individually for the unit.
For details about changing the setting, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
1.1.6 Web User Interface Programming
After connecting the unit to your network, you can configure the unit’s settings by accessing the Web user
interface from a PC connected to the same network. For details, see Section 4 Web User Interface
Programming.
1.1.6.1 Password for Web User Interface Programming
To program the unit via the Web user interface, a login account is required. There are 2 types of accounts, and
each has different access privileges.
• User: User accounts are for use by end users. Users can change the settings that are specific to the unit.
• Administrator: Administrator accounts are for use by administrators to manage the system configuration.
Administrators can change all the settings, including the network settings, in addition to the settings that
can be changed from a User account.
A separate password is assigned to each account.
For details, see Access Levels (IDs and Passwords) in 1.1.6.3 Before Accessing the Web User
Interface.
Notice
• You should manage the passwords carefully, and change them regularly.
Document Version 2011-06 Administrator Guide 19
1.1.6 Web User Interface Programming
To Next Page
Loading...
