Panasonic KX-UT133-B - Flexible Button Settings

Button Description Lamp Indication
BLF Used to show the current status of another
extension, call the extension and transfer
calls to it.
This button can also be used to perform
Directed Call Pickup (® see [Direct Call
Pickup] in 4.6.1.1 Call Control in the Web
user interface or
"NUM_PLAN_PICKUP_DIRECT" in 5.5.1 Call
Control Settings in the configuration file).
Note
• BLF (Busy Lamp Field) is an optional
feature and may not be supported on
your phone system.
• It may be necessary to specify the
Resource List URI to use this feature,
depending on the network
environment (® see [Resource List
URI] in 4.6.2.1 Call Control in the
Web user interface or
"RESOURCELIST_URI_n" in
5.7.1 Call Control Settings in the
configuration file).
Off: The BLF extension is idle.
Red on: A corresponding BLF extension is
using the line.
Flashing red rapidly: The BLF extension is
receiving an incoming call.
ACD Used to log in or log out of a group when ACD
(Automatic Call Distribution) is enabled.
Note
• ACD is an optional feature and may
not be supported on your phone
system.
Off: Logged in
Red on: Logged out
6.3.1 Flexible Button Settings
To set Flexible Buttons
1. In the Web user interface, click the [Telephone] tab, and then click [Flexible Button Settings].
2. Enter settings as described in the following table.
When it is necessary to set both parameter 1 and parameter 2, enter a comma between the values.
Button
Parameter 1 Parameter 2
Description Value Description Value
DN Ringtone 1–32 Line No. 1–4
One-Touch Phone Number Up to 32 digits
– –
Headset
– – – –
BLF Extension Number Up to 32 digits
– –
Document Version 2011-06 Administrator Guide 247
6.3.1 Flexible Button Settings