Button Function
Refresh Updates the status information displayed on the screen. This button is
displayed in the upper-right area of the [Network Status] and [VoIP Status]
screens.
Entering Characters
In the Web user interface, when specifying a name, message, password, or other text item, you can enter any
of the ASCII characters displayed in the following table with a white background.
However, there are additional limitations for certain types of fields as follows:
• Number field
– You may only enter a sequence of numeric characters.
– You cannot leave the field empty.
• IP Address field
– You can enter the IP address using dotted-decimal notation (i.e., "n.n.n.n" where n=0–255).
– You cannot enter invalid IP addresses, for example, "0.0.0.0", "255.255.255.255", or "127.0.0.1".
• FQDN field
– The field cannot contain ", &, ', <, >, or trailing spaces.
– You can enter the IP address using dotted-decimal notation (i.e., "n.n.n.n" where n=0–255).
– You cannot enter invalid IP addresses, for example, "0.0.0.0", "255.255.255.255", or "127.0.0.1".
• Authentication ID/Password field
– The field cannot contain ", &, ', :, <, >, or space.
– The length of user password and administrator password must be from 6 to 16 characters.
• Display Name field (® see [Display Name] in 4.6.2.1 Call Control)
– This is the only field in which you can enter Unicode characters.
Result Messages
When you click [Save] after changing the settings on the current configuration screen, one of the following
messages will appear in the upper-left area of the current configuration screen:
24 Administrator Guide Document Version 2011-06
1.1.6 Web User Interface Programming
To Next Page
Loading...
