115
8. Sensor
Adjust the compass when the measurement value does not match the actual bearing.
1 Select the menu.
2 Securely hold the unit vertically, and adjust by
turning it in a figure of 8 by rolling your wrist a
few times.
• An adjustment completed message is displayed
when the adjustment is successful.
Adjusting the compass
> [Setup] → [Calibrate compass]
• Perform the adjustment with the strap around your wrist to avoid dropping the unit.
• When the adjustment fails, move to a location with no effect from surrounding magnetism, and
perform the adjustment again.
MENU
To Next Page
Loading...
