11. Using the Wi-Fi function
158
∫ Recording location information and images
1 Start recording location information with the smartphone.
2 Record images with the camera.
3 Stop recording the location information with the smartphone.
∫ Writing the location information to the images
(Preparation on the camera)
Connect to a smartphone. (P152)
Operate the smartphone.
1 Start “Image App ”. (P151)
2 Select [ ].
3 Select [Geotagging].
4 Select [ ] to send and write the location information.
• Follow the on-screen messages to operate the smartphone.
• Images with location information are indicated with [ ].
1 Start “Image App”. (P151)
2 Select [ ].
3 Select [Geotagging].
4 Select [ ] to start recording location information.
Select [ ] to stop recording the location information.
• Cautions for Use:
Be sure to pay special attention to the privacy, the likeness rights, etc. of the subject
when you use this function. Use at your own risk.
• The smartphone battery drains faster while location information is being recorded.
When recording of location information is not necessary, stop it.
• On the smartphone, you can set the acquisition interval of location information and check the
transfer status of location information.
Refer to [Help] in the “Image App ” menu for details.
Not available in these cases:
• This function is not available in the following cases:
– Images recorded after location information was sent to the camera
– Images with location information already written to them
To Next Page
Loading...
Need help?
General
