87
5. 4K Photo and Drive Settings
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
1
Press 4 ().
2
Press 2/1 to select the burst icon ([ ],
etc.), and then press 3.
3
Select the burst speed with 2/1, and then
press [MENU/SET].
¢ When recording is performed under the test conditions specified by Panasonic.
The burst speed will become slower halfway. However, pictures can be taken until the
capacity of the card becomes full. Depending on recording conditions, the number of
burst pictures that can be taken will be reduced.
• The Burst speed may become slower depending on the following settings.
– [Picture Size]/[Quality]/[Sensitivity]
• Burst speed can also be set with [Burst Rate] in the [Rec] menu.
4
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
∫ Canceling the Burst Mode
Select [ ] ([Single]) or [ ] from among the drive modes. (P86)
Burst speed
(pictures/second)
Focus
Number of recordable
pictures
¢
10 Fixed to AF 11
5 AF tracking 15
2 AF tracking
Depends on the capacity
of the card
To Next Page
Loading...
Need help?
General
