17
1. Before Use
2 Tap the camera lightly against your palm while holding it upside down and then
with the illustrated side facing down, and then wipe off the water droplets with a
soft, dry cloth.
• Repeat this step a few times if water is left in the microphone A or speaker B hole.
If water is left in the microphone or speaker hole, weak or distorted audio may be recorded
and played back.
• Fasten the strap firmly to your wrist to avoid dropping the camera.
3 Dry the camera by standing it on a dry
cloth in a well ventilated shaded area.
• This unit incorporates drain design, draining
water in gaps in the camera [ON/OFF] button
and zoom button etc.
• Do not dry the camera with hot air from dryer or
similar. Waterproof performance will deteriorate
due to deformation.
4 Confirm that there are no water droplets, open the side door, and wipe off any
water droplets or sand left inside using a soft, dry cloth.
• Water droplets may adhere to the card or battery when the side door is opened without
thoroughly drying. Also, water may accumulate in the gap around the card/battery slot or
the terminal connector. Be sure to wipe any water off with a soft, dry cloth.
• The water droplets may seep into the camera when the side door is closed while it is still
wet, causing condensation or failure.
• When particles such as salt residues from seawater are
adhering to the camera, the arm of the side door and various
other components may whiten. Use damp cotton swabs or
similar to wipe until the whitened part is removed.
C Arm part
To Next Page
Loading...
Need help?
General
