GB6
Make sure to complete the preparation steps before setting menu.
Handling Instructions
Before Use
● For the first time use, remove packing material and
clean the machine.
(See P. GB7 of "OPERATING INSTRUCTIONS")
●
Clean the machine when you have not used for a
long time.
(See P. GB7 of "OPERATING INSTRUCTIONS")
Preparations
1
Open the lid, remove the bread pan (1) and set
the kneading blade into the kneading mounting
shaft. (2)
●
Check around the shaft and inside the kneading blade and
ensure that they are clean.
(See P. GB7 of "OPERATING INSTRUCTIONS")
Kneading mounting shaft
2
Prepare the ingredients with exact
measurement according to the recipe.
3
1
Place the measured ingredients into the
bread pan in the order listed in the recipes.
●
For bread and dough menus, dry yeast should be
placed first.
â
Place dry yeast away from the kneading blade and
kneading mounting shaft. If some of the dry yeast get
into it, bread may not rise well.
ê
Place dry ingredients over the dry yeast.
It must be kept separate from any liquid until mixing
commences.
●
Pour liquid in the edge of bread pan's sidewall to
avoid splashing. (3)
2
Wipe off any moisture and flour around the bread
pan, and return it into the main unit. (4) Close
the lid.
●
For optimum results, do not open the lid unless the menu
requires, as it affects bread quality.
4
Plug the machine into 230V~240V socket.
Baking Bread
5
Press or button in the Menu ( ) bar to
select a bread menu.
●
Choose the options for selected menu. (See P. GB5)
Crust colour Delay timer
6
Press Start ( ) button to start the machine.
(The display shows when menu "1" is selected.)
●
Display shows the remaining time until the selected program is
complete.
* The remaining time is changed depending on the room
temperature.
Remaining time
●
Do manual operation when the beep sounds if you select
the certain menus.
(See P. GB5, menus with
icon. )
After that, then press
button again.
* Complete the works while
is flashing on the display.
When
stop flashing, display shows the remaining time.
* Do not add ingredients after display shows remaining time.
* Kneading will continue after a certain time without pressing
button.
7
When bread is ready (machine beeps 8 times and
the cube (
) near End flashes), press Stop ( )
button and unplug.
8
Remove the bread immediately by using dry oven
gloves and place it on a wire rack. (5)
●
Hold the handle with oven gloves and shake the bread out.
Bread pan
Oven gloves
Make sure the blade has not
come out with the bread.
●
Moving the outside base shaft may damage the bread shape. (6)
Outside base
shaft of bread pan
(Bottom of bread pan)
●
Always remove the kneading blade before slicing bread. (7)
Turn to P. GB10 for
recipes
To Next Page
Loading...
