Parker 10G-46-0600-BF

Introduction 1-1
AC10 Inverter
Chapter 1 Introduction
This manual offers an introduction to the installation and connection for the AC10 series.
Parameters setting, software and operation are also covered in this manual.
1.1 Understanding the Product Code
Model Number
The unit is fully identified using a four block alphanumeric code which records how the drive
was calibrated, and its various settings when dispatched from the factory. This can also be
referred to as the Product Code.
Input voltage:
1 : 1 Phase 230V/240V
2 : 3 Phase 230V/240V
4 : 3 Phase 380V/480V
Industry
Rated current (A):
XXXX 
OOO.O
Product model
Frame Size: (mm)
1
:
2:
3:
4:
5:
F : Built in filter
N :
without built
in filter
10 G - 1 1 - 0015
-
B F
B
:
Built
-
in braking unit
80×135×138
106×150×180
138×152×235
156×170×265
205×196×340
6
:
7:
8:
9:
10:
265×235×435
315×234×480
360×265×555
410×300×630
516×326×765
-
-
11:
560×342×910
1.2 Nameplate Example
This example nameplate shows the product as an AC10 series IP20 2.2kW inverter with 3-
phase input.
3Ph: three-phase input; 380-480V, 50/60Hz: input voltage range and rated frequency.
3Ph: 3-phase output; 6.5A, 2.2kW: rated output current and power;