Parker 10G-46-0600-BF

Questions and Answers

M
Matthew BellSep 23, 2025
What if I entered the wrong password on my Parker Controller?
- B
  bateslisaSep 23, 2025
  If you entered the wrong password on your Parker Controller when the password function is valid, set the password correctly.
M
Margaret BradfordAug 23, 2025
What to do if my Parker Controller displays 'Inverter Overload'?
- L
  Lauren HawkinsAug 23, 2025
  If your Parker Controller is showing an inverter overload, it could be due to a load that is too heavy. Try to reduce the load, check the drive ratio, or increase the inverter’s capacity.
C
Christopher MatthewsAug 25, 2025
What causes a Parker Controller to display 'Motor Overload'?
- B
  Brooke LynchAug 26, 2025
  A 'Motor Overload' message on your Parker Controller typically indicates that the load is too heavy. You should reduce the load, check the drive ratio, or increase the motor’s capacity.
M
Matthew CalderonAug 26, 2025
What should I do if my Parker 10G-46-0600-BF shows DC Over-Voltage?
- T
  Thomas WalkerAug 27, 2025
  If your Parker Controller displays a DC Over-Voltage error, consider the following potential causes and solutions: 1. Supply voltage too high: Check if the rated voltage is input. 2. Load inertia too big: Add braking resistance (optional). 3. Deceleration time too short: Increase deceleration time. 4. Motor inertia rise again: Set the parameter of rotary speed loop PID correctly. 5. Parameter of speed loop PID is set abnormally: Set the parameter of rotary speed loop PID correctly.
M
mandersonAug 27, 2025
What to do if Parker Controller shows Current Zero Excursion Malfunction?
- K
  Kelly DavisAug 27, 2025
  If your Parker Controller shows a 'Current Zero Excursion Malfunction', check the flat cable. If the issue persists, contact Parker.
E
elizabeththomasSep 18, 2025
How to fix communication timeout on Parker 10G-46-0600-BF Controller?
- V
  Veronica ChurchSep 18, 2025
  To fix a communication timeout on your Parker Controller, check whether the communication line is connected reliably.
L
Leslie ThompsonSep 15, 2025
What causes the wrong direction of motor running on a Parker Controller?
- J
  Jessica AllenSep 15, 2025
  If the motor is running in the wrong direction with your Parker Controller, check if the U, V, W wiring is correct and ensure the parameters are set correctly.
J
Jacqueline GriffithSep 16, 2025
What does 'Line Disconnected' mean on my Parker Controller?
- L
  Laura SandovalSep 17, 2025
  If your Parker Controller displays 'Line Disconnected', it indicates that the analog signal line is disconnected or the signal source is broken. Try changing the signal line or the signal source.
L
Laura RollinsSep 6, 2025
What causes a Parker 10G-46-0600-BF to have output phase loss?
- M
  Michael CantrellSep 6, 2025
  An output phase loss in your Parker Controller could be due to a broken motor, loose motor wires, or a broken inverter. Check if the motor is broken, if the motor wires are loose, and if the inverter is broken.
H
hallrachelSep 4, 2025
What to do if my Parker Controller trips the power?
- Y
  yorkcarrieSep 4, 2025
  If your Parker Controller is tripping the power, it might be because the wiring current is too high. Check the input wiring, select a matching air switch, reduce the load, and check for any inverter malfunctions.