What causes a Parker 10G-46-0600-BF to have output phase loss?
An output phase loss in your Parker Controller could be due to a broken motor, loose motor wires, or a broken inverter. Check if the motor is broken, if the motor wires are loose, and if the inverter is broken.
Why does my Parker 10G-46-0600-BF show an overcurrent?
An overcurrent in your Parker Controller can occur due to several reasons. It might be caused by: * Too short acceleration time: Prolong the acceleration time. * A short circuit at the output side: Check if the motor cable is broken. * A locked rotor with the motor: Verify if the motor is overloaded. * Incorrect parameter tuning: Reduce the VVVF compensation value and measure the parameters correctly.
What to do if my Parker Controller trips the power?
If your Parker Controller is tripping the power, it might be because the wiring current is too high. Check the input wiring, select a matching air switch, reduce the load, and check for any inverter malfunctions.
What to do if Parker Controller motor is running unstable?
If your motor is running unstable with the Parker Controller, it could be due to: * Too big load? Reduce load. * Too big with load change? Reduce load change, increase capacity. * Phase loss? Correct wiring. * Motor malfunction.
How to resolve 'Flycatching Fault' on Parker 10G-46-0600-BF?
To resolve a 'Flycatching Fault' on your Parker Controller, try tracking again. If the issue persists, contact manufacturer.
What to do if Parker 10G-46-0600-BF shows Current Malfunction Before Running?
If your Parker Controller shows a 'Current Malfunction Before Running', it means a current alarm signal exists before running. Check if the control board is properly connected to the power board.
What causes a 'Parameters Tuning Wrong' error on a Parker 10G-46-0600-BF?
A 'Parameters Tuning Wrong' error on your Parker Controller indicates that incorrect motor parameters have been entered. Connect the motor correctly.
What to do if Parker Controller shows Current Zero Excursion Malfunction?
If your Parker Controller shows a 'Current Zero Excursion Malfunction', check the flat cable. If the issue persists, contact Parker.
What should I do if my Parker 10G-46-0600-BF shows DC Over-Voltage?
If your Parker Controller displays a DC Over-Voltage error, consider the following potential causes and solutions: 1. Supply voltage too high: Check if the rated voltage is input. 2. Load inertia too big: Add braking resistance (optional). 3. Deceleration time too short: Increase deceleration time. 4. Motor inertia rise again: Set the parameter of rotary speed loop PID correctly. 5. Parameter of speed loop PID is set abnormally: Set the parameter of rotary speed loop PID correctly.
What causes a Parker Controller to display 'Motor Overload'?
A 'Motor Overload' message on your Parker Controller typically indicates that the load is too heavy. You should reduce the load, check the drive ratio, or increase the motor’s capacity.
General| Brand | Parker |
|---|---|
| Model | 10G-46-0600-BF |
| Category | Controller |
| Language | English |
To Next Page