Pentax R-2500DN Series - Page 16

15
LED Description
NONE Battery is not seated correctly
GREEN Battery is fully charged
RED Battery is being re-charged
Flashing RED Charge error or bad battery
Afullydischargedbatterywilltakeapproximately 2hourstofullychargeand
maynotlighttheLEDstatusindicatorwhenfirstmounted.
[Battery Installation and Replacement]
RemovingthebatteryinusewillcausetheR‐2500DNtorestartorturnOFF.Usethe
batterystatusindicatorindatacollectionsoftwaretoconfirmwhichbatteryis“in
use”beforehot‐swappingbatteries.
• Press button to open battery door compartment
• Use the guide to slide the battery into the R-2500DN
• Swivel the battery door compartment up and push from the bottom until it latches completely
What you need to know
Can I remove one of the
batteries while the R-
2500DN is in use?
Before battery removal, use data collection software
to check which battery is in use. Remove the battery
not in use
How long does it take to
charge a battery?
It takes 2 hours to fully charge a battery
How do I know if battery
is fully charged?
Battery bay LED turns Green when fully charged
ContactaRecyclingCentertoensureproperdisposaloflithium‐ion
Batteries.