55
1. Selection of Transfer rate (baud rate): [BAUD RATE]
Select a baud rate of 1200, 2400, 4800 or 9600.
2. Selection of Data bits: [DATA LENGTH]
Select a data length of 8 bits.
3. Selection of Parity: [PARITY BITS]
Select no (NIL) parity bit, even parity or odd parity.
4. Selection of Stop bit: [STOP BITS]
Select the number of stop bits to be used: 1 or 2.
5. Selection of Control signal: [SIGNAL CONTROL]
Select whether the control signal is effective or not.
6. Selection of XON/XOFF: [XON/XOFF]
Select whether to enable or disable XON/XOFF.
7. Selection of Through command
: [THROUGH COMMAND]
Select whether to disable data output
without receiving any data request command
or enable the “a” to “f” command data output.
X1.1200XXX
2.2400
3.4800
4.9600
X1.8XXXXXXXXXXXX
X1.NILXXXXX
2.EVEN
3.ODD
X1.1XaXXXXXX
2.2
X1.ONXaXXXXXX
2.OFF
X1.ONXaXXXXXX
2.OFF
X1.NILXXXXXXXXXX
2.a
3.b
4.c
5.d
6.e
7.f
To Next Page
Loading...
