Quantum GX2 microCT Imaging System Manual Chapter 2 | Safety, Warnings, and Radiation Hazards 10
2.2 Warnings
Electrical Safety
X-Ray Safety
Mechanical Safety
The Quantum GX2 microCT Imaging System is heavy and weighs approximately 600 kg. The
imaging system has many internal motorized components that can move at any time.
The X-ray flat panel detector and source located inside of the bore area are delicate parts and should
not be handled with bare hands or sprayed with cleaning agents.
VOLTAGE! DO NOT attempt to service the Quantum GX2 microCT Imaging System
yourself. Although there are no voltages in excess of 24V inside the sample bore area,
high voltages are present behind interlocked access panels. Contact PerkinElmer
technical support for electrical service needs.
CAUTION: Depending on environmental or use conditions, such as humidity, using
the equipment without grounding may lead to electric shock. To ensure safety,
securely connect the ground wire of the power cable or the ground terminal of the
equipment (Class D grounding) to ground.
WARNING! The equipment produces X-rays when energized.
WARNING! The Quantum GX2 microCT Imaging System should be operated
only by personnel who have been trained in radiation safety and the operation
and safety instructions contained in this manual. PerkinElmer also
recommends that personnel who operate the equipment, or are close proximity
to the equipment, use a radiation film badge or other type of appropriate
personal dosimeter.
WARNING! If the gas hoses become caught, kinked, or disconnected, do not operate
the imaging system. Over exposure to anesthesia gas may occur.
CAUTION: The bore cover and the sample bed are made of an acrylic material. To
avoid damage, do not wash with organic solvents.
CAUTION: Confirm that the sample and the sample bed are not in the sample chamber
during the system warm-up. If so, the detector may be damaged by overexposure,
resulting in degradation of the CT image.
To Next Page
Loading...
Need help?
General