197
Serial Port Profiles
General Tab Field Descriptions
Configure the following parameters:
Act As Tunnel
Server
The IOLAN will listen for an incoming connection request on the specified
Internet Address on the specified TCP Port.
Default: Enabled
TCP Port The TCP port that the IOLAN will listen for incoming connection on.
Default: 10000+serial port number; so serial port 5 is 10005.
Act as Tunnel
Client
The IOLAN will initiate the connection the Tunnel Server.
Default: Disabled
Host Name A preconfigured host name that is associated with the IP address of the Tunnel
Server.
TCP Port The TCP port that the IOLAN will use to connect to the Tunnel Server.
Default: 10000+serial port number; so serial port 5 is 10005.
HTTP Tunnel Specify the HTTP tunnel to be used for this connection.
Enable TCP
Keepalive
Enables a per-connection TCP keepalive feature. After the configured number
of seconds, the connection will send a gratuitous ACK to the network peer,
thus either ensuring the connection stays active OR causing a dropped
connection condition to be recognized.
This parameter needs to be used in conjunction with
Monitor Connection
Status Interval
parameter found in the Serial, Advanced, Advanced Settings
tab. The interval specifies the inactivity period before "testing" the connection.
Default: Disabled
To Next Page
Loading...
