Hardware and Connectivity 28
Power Supply Specifications
z Power cord strain relief strap
z Wall Mount brackets
z Rubber feet
What You Need to Supply
Before you can begin, you need to have the following:
z A serial cable(s) to connect serial devices to your IOLAN unit
z An Ethernet CAT5 10/100 or CAT5 10/100/1000BASE-T cable to connect the IOLAN unit to the
network (IOLAN W/L/G models support 1000 Mbps Ethernet)
z SFP module/s and associate Fiber or Ethernet cable for SCS16C-DSFP model
z Connection to power (Only applies to DC, I/O, Terminal Block and Electric Utility models)
z Data Plan subscription with a supported carrier and activated 3FF Sim Card for SDS L models
only.
Available Accessories
The following accessories are available for purchase for the various IOLAN models (except medical
unit models):
z DIN Rail Mounting Kit for the desktop models and Electric Utility models.
z IOLAN modem card for SCS rack mount models
z PCI adapter card for SCS rack mount models (for wireless WAN cards, modem cards and fiber
LAN cards)
z 3 meter RJ45M-RJ45M 8-wire Sun/Cisco modular cable
z RJ45 to DB25 DTE Male adapter
z RJ45 to DB25 DCE Male adapter
z RJ45 to DB25 DTE Female adapter
z RJ45 to DB9 Male DTE adapter
z RJ45 to DB9 Female DTE adapter
Contact your distributor for details.
Power Supply Specifications
Desktop Models (DS and SDS)
If you are providing a power supply for a desktop IOLAN model, your power supply must meet the
following requirements:
z DC barrel connector: The cable attached to the power supply should be about 20AWG. The
barrel dimensions of the cable-plug are OD=5.5, ID=2.1, and length= 9.5mm, with a straight
barrel, and positive polarity on the inside and negative polarity on the outside. The voltage
output should be between 9-30VDC and a minimum of 700 mA.
z Terminal Block connector: The cable attached to the power supply should be about 20AWG. See
the Quick Start Guide for your model to determine the power requirements
Power can also be provided by:
z Serial Port 1, pin 1 on the DS/SDS1 models
z Serial Port 2, pin 1 on the SDS2 models
z Serial Port 4, pin 1 on the SDS4/SCS4 /SCS4 HL models
z Ethernet on the P series models (Power over Ethernet)
To Next Page
Loading...
