Accessories 456
Removing SFP modules from SFP’s slot/s
Removing SFP modules from SFP’s slot/s
1. Disconnect the fiber cable from the SFP module.
2. If the SFP module is equipped with a clasp, move it to the unlocked position and use the clasp to
pull the SFP towards you.
3. If the SFP module is not equipped with a clasp, then with your fore finger and thumb, firmly grip
the SFP and pull towards you.
Note:
WARNING
In hazardous location installations, failure to remove the power from the source prior to
completing the connection/s to the SFP slot/s could cause an electrical arc resulting in a
possible explosion.
SFP Slots
To Next Page
