232
Serial Port Profiles
Session Strings Controls the sending of ASCII strings to serial device at session start as
follows;
z Send at Start—If configured, this string will be sent to the serial device
on power-up of the IOLAN, or when a kill line command is issued on this
serial port. If the "monitor DSR" or "monitor DCD" options are set, the
string will also be sent when the monitored signal is raised.
Range: 0-127 alpha-numeric characters
Range: hexadecimal 0-FF
z Delay after Send - If configured, will inset a delay after the string is sent
to the device. This delay can be used to provide the serial device with time
to process the string before the session is initiated.
Range is 0-65535 ms
Default: 10 ms
To Next Page
Loading...
